The building frame longitudes and
bulkheads for the floats (MDF and plywood) was cut out and assembled. The frame
slots together and is self-aligning. The building frame bulkheads were rounded
on the bilge panel which is different to the original boat which has chines.
The side panel and the bottom panel were attached using gyprock screws.
Then the bilge panel was strip planked
using laminated foam strips. Each was screwed to the building frame and glued
to the one below. Then glass was laminated over the bilge and bottom panel.
The hull was taken off the building
frame and glass was applied over the strip plank area.
No comments:
Post a Comment