The ring frame was taped to the main hull, inside and out. The floor was cut to fit and all the lockers cut out. All the foam was dug out onthe edges of the lockers and filled with bog. The centreboard case was taped in.
I painted under the floor (inside the lockers) because it is hard to paint in these areas after the floor is installed.
The temporary frame for the cabin top was built and the cabin sides attached. The sides were only temporarily attached because the cabin topwill be removed to finish inside.
Total time 356 hours
Friday, February 20, 2009
Wednesday, February 18, 2009
Scarab 18 folding trimaran Part 9
We live in a pretty remote area and the only internet we have here is wireless which doesn't work when it is raining or too windy. So it's up to the weather when I can post to this blog.
Friday, February 6, 2009
Scarab 18 folding trimaran Part 8
Scarab 18 folding trimaran Part 7
I have jumped from one job to another in this blog because this is how I work. The object is to have as many jobs going at the same time to avoid wasting time. The main reason for this blog is to show how easy the construction is and how many hours it takes for one person to build this boat.
To see a more organised layout see www.teamscarab.com.au/S18designnotes.html
Instead of precovering the panels for the float deck they are covered in place. The laminate is too stiff to bend in the required curve. Scraps of foam are screwed to the side of the float and the foam bent over and attached through the scrap piece.
The deck is laminated with glass cloth and resin. The deck can be removed when it is ready by taking the screws out of the scrap piece of foam and lifting it off the float. Trim the edge and laminate glass cloth on the underside of deck.
Attach the deck with glue and hold down with metal straps until dry. Sand the edges, fair and tape.
Bulkheads were tacked in place in the main hull.
Total time 262 hours
To see a more organised layout see www.teamscarab.com.au/S18designnotes.html
Instead of precovering the panels for the float deck they are covered in place. The laminate is too stiff to bend in the required curve. Scraps of foam are screwed to the side of the float and the foam bent over and attached through the scrap piece.
The deck is laminated with glass cloth and resin. The deck can be removed when it is ready by taking the screws out of the scrap piece of foam and lifting it off the float. Trim the edge and laminate glass cloth on the underside of deck.
Attach the deck with glue and hold down with metal straps until dry. Sand the edges, fair and tape.
Bulkheads were tacked in place in the main hull.
Total time 262 hours
Subscribe to:
Posts (Atom)
Scarab 16 beams part 3
I painted the beams to match the rest of the boat using 2 pack epoxy primer and Jotun Imperite (Home Yellow). The aluminiu...
-
I have been busy with many projects lately. The Scarab 18 has been painted and Ray is finishing the boat himself. If you want to see more pi...
-
A few years ago Ray designed a small trimaran to be sold as a kit using plywood. It was 3m long and met the international 3 metre rules. It ...
-
One more beam finished (two down – two to go). I’ve been asked to provide more information and more pictures, so here we go. The mould was b...